Produtos similares
O texto nas imagens pode ser traduzido
Adequado para Decoração de Cubo Interno de Porta Jed anel brilhante Cubo de Porta de Maçaneta Jed patch resistente a arranhões suprimentos de peças de automóvel
Certificação necessária
90 dias
Mín. R$ 253.548 (5.810 un.)
Produto 5.0
Fornecedor 4.5
Quantidade
[Bright surface * 4] Plastic
Correspondências exatas por um preço menor
Produtos similares a um preço mais baixo
Especificações do produto
Marca
Glins.
Material
Plastic
Origem
Guangzhou
Modelo
Inner door Bowl
Logotipo impresso
No.
Cor
[Bright surface * 4] Plastic
Marca
Glins.
Material
Plastic
Origem
Guangzhou
Modelo
Inner door Bowl
Logotipo impresso
No.
Cor
[Bright surface * 4] Plastic
Marca
Glins.
Material
Plastic
Origem
Guangzhou
Modelo
Inner door Bowl
Logotipo impresso
No.
Cor
[Bright surface * 4] Plastic
Detalhes do produto
O texto nas imagens pode ser traduzido
Installation Notes
1. Simulate installation
1. Simulate installation
Compare the location where the product is to be installed on the vehicle and adjust it to the exact location.
2.Surface treatment
(1) Cleaning
Use a towel dipped in alcohol or clean water to clean the car body in the area that needs to be installed.
(2) Precautions
Before installation, keep the car body dry and free of dust, oil, and wax. When the temperature is below 10 degrees, be sure to heat the double-sided tape on the car body and product.
(3) Use of tackifiers
Use a cotton swab or paper towel (a small amount) to wipe the area to be glued (car body)
(4) Installation
First tear off a corner of the double-sided tape protective film on the back of the product, leaving the film outside so that the product fits the installation position, then slowly tear off the film and press it.
(5) period
Within 48 hours after the product is installed (where the glue is applied), it must not be exposed to water, oil, or large dust.
Note: Please compare before installation. Tear off the red film on the back and no returns or exchanges will be accepted.
(3) Use of tackifiers
Use a cotton swab or paper towel (a small amount) to wipe the area to be glued (car body)
(4) Installation
First tear off a corner of the double-sided tape protective film on the back of the product, leaving the film outside so that the product fits the installation position, then slowly tear off the film and press it.
(5) period
Within 48 hours after the product is installed (where the glue is applied), it must not be exposed to water, oil, or large dust.
Note: Please compare before installation. Tear off the red film on the back and no returns or exchanges will be accepted.
Total